Ducati Diavel Fender Eliminator Kit Instructions
1) Remove stock license plate fender
2) Remove seat and slide back passenger handle
3) Locate the dimple in the center of the casting (Image 1)
4) Drill through casting using a 13/64” drill bit
5) Using one of the mounting bolts provided, hold in place the license plate and mark your location for the lower hole (Image 2)
6) Using the 13/64” drill bit, drill out your lower hole
7) Using provided hardware, tighten down license plate bracket
8) Mount your license plate to the new bracket
9) Route LED wire to running light circuit
Shop The Part
New Rage Cycles
Ducati Diavel 2 Position Fender Eliminator (2010 - 2019)
Custom designed two position fender eliminator bracket eliminates the stock license plate fender, while offering a clean and fully functional license plate bracket.
- 2 Position Plate allows for easy access to storage key
- License plate comes with a running light and bracket that mounts to the top.
Please note: 2 holes must be drilled into passenger handle casting. Install in less than 30 minutes.
(2010 - 2019)