Ducati Scrambler Sixty2 Front Turn Signals Instructions

1) With a 10mm wrench and a 5mm allen key, remove bolt from stock signal (picture 1)

2) Remove phillips head screw from stock signal (picture 2)

3) Pop apart stock turn signal, and slide out 2 spade connectors (picture 3)

4) Remove 2 flat head screws from lower plate on NRC turn signal (picture 4)

5) Using 8mm wrench and 3mm allen key or socket, tighten flat head bolt through to nut on the lower plate to mount onto the bike (picture 5)

6) Adjust lower plate to desired angle (picture 6/7)

7) Feed wire through hole, plug in male spade connectors to female connectors and shrink tube your connections (picture 8)

8) Reinstall removed screws from lower plate and tighten into lens (Do Not Over Tighten) (picture 9)