Kawasaki Ninja 300 Fender Eliminator Instructions

1) Using a 4mm allen key or socket, remove side panels from both sides (picture 1)

2) Using a 5mm allen key or socket, remove seat bolts from both sides (picture 2)

3) Using a 10mm socket, remove bolts for seat bracket (picture 3)

4) Unplug (3) connectors for turn signals and license plate light (picture 4)

5) Using a 5mm allen key or socket, unbolt (4) bolts and remove stock fender (picture 5)

6) Remove plastic spacer and hardware from bag

7) Mount spacer between bolt holes, and use M6x25 bolts and tooth washers to mount turn signal bracket onto bike (picture 6/7)

8) Feed connectors through seat and plug back into stock harness (picture 8)

9) Take M6x10 bolts and tooth washers to mount your license plate (picture 9)

10) nstall load equalizer/resistor. Wiring diagram is on bag (picture 10)

11) Turn bike on and test signals to make sure everything works properly

12) Reinstall seat bracket, side pods, and seat