KTM SuperDuke 1290 Fender Eliminator (2014-2019) Instructions

KTM SuperDuke 1290 Fender Eliminator (2014-2019) Installation Instructions

1) Remove seat and unplug 4 wire white connector (picture 1)

2) Remove (4) T30 torx bolts and slide fender off (picture 2)

3) To remove wiring harness, disassemble fender by removing all (12) screws (picture 3)

4) Unplug (3) white connectors and plug back into 4 pin connector under seat (picture 4)

5) Remove (2) T27 torx bolts underneath bike 

6) Take NRC kit, slide connectors through hole below stock tail light, insert two tabs into lower slots and use stock T30 torx bolts to tighten (picture 5/6)

7) Take (2) black spacers and M5x45 bolts and mount into lower holes underneath bike (picture 7)

8) Plug connectors into harness underneath seat and test lights (picture 8)

9) Zip tie if necessary and put tool bag and seat back on bike