Triumph Bonneville/Scrambler Fender Eliminator Kit Instructions

Triumph Bonneville/Scrambler Fender Eliminator Kit Installation Instructions

1) Remove seat from bike via 2 allen bolts (picture 1)

2) Unplug stock wiring harness (picture 2)

3) Loosen 4 bolts to remove stock fender (picture 3 / 4)

4) Using stock hardware, bolt in supplied splash shield (picture 5)

5) Bolt in NRC license plate bracket (picture 6)

If using grab handle:
With seat in hand, use stock hardware and supplied nuts to bolt into 2 top holes on bracket (picture 7)
• Fit seat onto bike, and with supplied hardware, bolt into 2 lower holes on bracket (picture 8)
• Plug new wiring harness into stock connector

If removing grab handle:
• Fit seat onto bike, use stock hardware and bolt into top 2 holes on bracket
• Plug new wiring harness into stock connector
• Using supplied rubber bumpers, install into 2 back rubber grommets on bike